How To Install Top Kitchen Cabinets
Then drill and or saw out the openings. Learn how to hang kitchen wall cabinets and install island cabinets with these pro tips.
Mark up the wall first.
How to install top kitchen cabinets. A ledger is a board that helps support the cabinetry as. Secure a ledger support board to the wall screwing it into the marked studs. The first thing you need to do is have a design plan.
It s crucial to know how you want the cabinets to look and be arranged in your kitchen. Extend that level line along the walls that will hold cabinets. Make plumbing and electrical cutouts.
Measure the height of the base cabinets. How to install wall and base kitchen cabinets step 1. Use a pencil to mark a level line on the wall.
You may need to cut the counter top short so that it will set in if it is between two walls. Most standard cabinets are 34 1 2 high. Lay out plumbing and electrical openings on the cabinet back using the layout lines on the wall as reference points.
Clamp drill and fasten. Lay a straight 8 foot long 2 x 4 inch board on the floor against the wall and place a carpenter s level on top of it. Using the outline you.
Attach as many cabinets together as you can safely lift and. Position the first cabinet. The counter top should be the next task once the cabinets have been completed.
For the upper cabinets measure a point approximately 54. Remove cabinet doors and drawers. How to install kitchen cabinets step 5.
There are a variety of things to consider when planning and preparing for a kitchen cabinet installation job. Tips for how to install cabinets successfully. Cut it to length if required and cut out the sink opening and the opening for the stove hob if it will be built in.
Test fit the counter top. Kitchen floor cabinets photo 7. Cabinet heights vary from one manufacturer to another but in general average 35 inches from the top of the lower cabinet to the floor.
Start with the upper cabinets. 1 preparing for cabinet installation. Begin your installation with a corner cabinet or from the far left if you don t have a corner unit.
Start by attaching a straight 1 by 4 ledger level on the wall at the 54 inch line. To find the high spot of the floor. Shim the low end until you get a level reading.
